|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
rear fender light assem.
anyone know what size scews/bolts are used on those two little white things that hang down on the rear fender to hold the rear light subassembly on the 2011 bikes? I gotta mount this up so i can plate my bike!! Trying to keep hte guessing to a minimum!!
|
#2
|
||||
|
||||
I use sheet metal screws, can't remember the size off the top of my head - maybe #8x3/4" long?
|
#3
|
|||
|
|||
ok part 2 ...
I went with the stock set up because I wanted the built in grab holds ... looking at it tonight ... its looking like there won't be any room on the muffler side. Some of the plastic might even have to be hacked off to get it to fit with the fmf Q in place.... or if it fits there is no way in hell there would be room for a hand. anyone got the stock assembly in place on an 11 with the fmf Q?? how is the fit? no go for the hand hold?? |
#4
|
||||
|
||||
You will have to go with the FMF Turbine Core or Leon Vince silencers to make the hand hold usable.
|
#5
|
||||
|
||||
It fits but you gotta have small hands to make the grab handle work.
|
#6
|
||||
|
||||
It still works as a hand hold even though I have to grab it a little farther to the rear than where the finger indents are.
__________________
2011 EC300 |
#7
|
|||
|
|||
Quote:
Thanks for the replies guys! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rear fender | weaver | Enduro Chassis & Body | 1 | 07-10-2011 07:20 AM |