|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
big end bearing
Having to rebuild a mates 2011 ec200 due to the plastic crank insert coming loose and glueing itself all over the top end. We're hoping the bottom end will be ok and trying to get away with not having to buy a new rod kit.
Can someone tell me if the big end rod bearing is an off-the-shelf bearing shop size or a proprietary gasgas bearing? Thanks Ps, obviously the motor hasn't been split yet or we'd be able to find out. Just hoping we don't have to buy a rod kif just to replace one bearing.
__________________
2011 Gasgas EC200, 1966 BSA 350 scrambles, 1972 Montesa cota 247 |
#2
|
||||
|
||||
Rod kit is the same as the CR250, so probably.
|
#3
|
|||
|
|||
I think I got my bearings of the shelf. find the part numbers on the bearings and google them and see what comes up
__________________
03 ec300 honda cr500 94 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Which Bearing's should I replace ? | EC250 | Enduro Chassis & Body | 4 | 11-28-2013 06:56 PM |
Wrist Pin Bearing 250/300 | JP4 | Enduro Engine - 2 stroke | 1 | 10-28-2013 09:13 PM |
Big End Bearing | twistywizard | Enduro Engine - 2 stroke | 15 | 01-26-2011 06:33 PM |
bearing sizes pv ? | stainlesscycle | Enduro Engine - 2 stroke | 3 | 08-23-2010 07:38 AM |
Wrist Pin Bearing | SpeedyManiac | Enduro Engine - 2 stroke | 16 | 10-08-2009 09:37 PM |