![]() |
|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
![]() |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]()
According to the VSDST software from technoresearc, my tps only registers 59.7 degrees at WOT, 4.1 degrees at closed(idle).
Is this adjustable or is my tps bad and need replacement? |
#2
|
||||
|
||||
![]()
After moving around and pushing the connectors for the tps and the ecu tps readings are now normal, 5.7 deg to 83.4 deg at WOT.
|
#3
|
|||
|
|||
![]()
I wonder what resistance it has at Closed throttle compared to WOT..
__________________
"It's Nature that Brings out the Madness" GasGas FSR450 07' |
#4
|
||||
|
||||
![]()
I used a cheap multi-meter and measured resistance. The tps is setup to deliver a voltage to the ecu, the potentiometer is supplied +5v and gnd, and center output is the metering circuit.
The resistance between gnd and output is 1.35 kOhms at idle, and 2.15 kOhms at wot |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Handlebar mounting position | bchatt | Enduro Chassis & Body | 8 | 10-14-2010 06:34 AM |
neddle position Question | biggstr6 | Enduro Intake/Carburetion - 2 stroke | 8 | 05-12-2010 11:26 AM |
oil sensor 450fse 03 | jjbaker1 | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 03-12-2009 06:54 AM |
Odo sensor on B/O | TooBadBrad | General Discussions & Announcements | 2 | 06-21-2007 08:23 PM |
Clip position ? | thingymijig | Enduro Intake/Carburetion - 2 stroke | 3 | 03-01-2007 05:57 AM |