|
|
|||||||
| Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-13-2011, 03:10 PM
|
||||
|
||||
Removing Factory dust cover on 45mm zokes
Is there a simple way to do this? Its not just a matter of prying off with a flat balde screw driver like the videos show. Its almost like they are molded on.
Well I got one done. Not as easy as the videos show . I guess I'm just not a very good mechanic. Last edited by biggstr6; 03-14-2011 at 08:37 AM. 
|
|
#2
03-14-2011, 11:07 AM
|
||||
|
||||
|
Must not have been prying hard enough . Second came out just like the viddeos.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removing '05 airbox cover | Trooper Sam | Enduro Chassis & Body | 7 | 01-23-2012 12:19 PM |
| Removing the fork cap? | sanderjavant | Enduro Suspension | 4 | 07-22-2007 12:35 PM |
| Another must-see movie: From Dust to Glory | MattR | Pictures & Videos | 5 | 09-08-2006 08:42 PM |
Linear Mode
