#21
|
||||
|
||||
Quote:
This Brembo bore is stamped 10. I'm not sure what the AJP is. You know?
__________________
2011 Gas Gas EC300 38mm, 2008 Husky TE610, 2003 Beta Rev3 250 |
#22
|
||||
|
||||
If its like the Magura it's the bore dia. Their way of designating displacement. This was being discussed in another thread. The AJP is not marked, but seems to be a bit less displacement. You should get slightly more travel, so less drag, but a slightly harder pull. When you put it together and bleed it just make sure the slave doesn't overtravel. Gasgasman swapped in a 10.5 Magura so you should be fine.
|
#23
|
||||
|
||||
I went to Autozone to look for some hydraulic jack oil and found this.
Would this be a suitable substitute for clutch mineral oil? |
#24
|
||||
|
||||
Clutch Hydraulic Fluid ?
If your gonna substitute just use baby oil. Works like a charm, smell only lasts a few hours.
Not to mention it is very cheap.
__________________
2013 GasGas 300 2004 GasGas 200 2011 GasGas 300 Ortonville Minnesota |
#25
|
||||
|
||||
I thought I had read somewhere that the johnsons baby oil was too thick?
|
#26
|
||||
|
||||
Clutch Hydraulic Fluid ?
I have used it for 4 yrs now, no issues. If you looks it's like 99.7% mineral oil. My percentage is wrong pry but close.
__________________
2013 GasGas 300 2004 GasGas 200 2011 GasGas 300 Ortonville Minnesota |
#27
|
|||
|
|||
Been using ATF since 2000....Dextron 2. Not sure what the boiling point is of baby oil, but I've yet to burn up ATF.
I've also seen 5wt fork oil used. |
#28
|
||||
|
||||
Ok thanks guys.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hydraulic Clutch on EC 250 not engaging | jprh | Enduro Engine - 2 stroke | 2 | 03-01-2009 05:54 AM |
Hydraulic Clutch Oil?? | jyellard | Enduro Chassis & Body | 10 | 10-01-2008 01:34 AM |
Hydraulic Fluid for the clutch | lukachuki | Enduro Engine - 2 stroke | 2 | 09-22-2007 05:59 PM |
Im looking for a Grimeca Hydraulic Clutch | brian27 | General Discussions & Announcements | 3 | 06-21-2007 02:33 PM |