|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
pv bearing size
hi, can someone post pv bearing sizes/numbers - wanted to order some/check if i have them in stock for a rebuild, and don't have the numbers handy - i know there's 2 of one size, and 1 of the other.... thanks!
i did some quick research - is it 608 (2) and 6000 (1) - open bearings i assume ?
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#2
|
|||
|
|||
Sorry, don't remember seeing actual size stated but they fit Rollerblades!
I do know that the outside bearing on the left side is sealed. I think both of my left side bearings are sealed, but the Powervalve Tech article with the exploded view shows only the outside one sealed. Right one is open.
__________________
Ross '05 MC 250 '91 Husky 610wxe '04 Duc M800 R.I.P '06 Duc S2r 1000 R.I.P '07 Duc S2r 1000 still rubber side down... ---------------------------------------------------------- May be so... May be not so... My Website |
#3
|
||||
|
||||
All my bearings from stock were sealed. I replaced them all with sealed bearings too. Not sure if I held onto the ones I replaced or not.. I'll have a look down the shed later.
|
#4
|
|||
|
|||
Bearings
I have just replaced mine recently. On the stock setup the 2 small bearings were only sealed on one side. It was the same with the larger bearing as well. I replaced them with bearings that were sealed on both sides. Everything worked well for about 50 miles of riding until my PV stuck in the closed position. I have not cracked it open yet to set what went bad. Hopefully the new bearings are not the problem.
2004 EC 300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GG 200 size | Darkside | General Discussions & Announcements | 21 | 01-31-2012 10:57 PM |
What size of piston? | Todd5774 | Enduro Engine - 2 stroke | 3 | 10-24-2011 03:20 PM |
Big End Bearing | twistywizard | Enduro Engine - 2 stroke | 15 | 01-26-2011 06:33 PM |
Nut Size | steve | Enduro Engine - 2 stroke | 2 | 01-11-2008 10:58 AM |