|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Periodically remove and re-fit all bolts?
Just wondering since the swing-arm is out I may remove and re-fit the bolts in there for no other reason than to stop them seizing in the future - is it worth it, would you do it?
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#2
|
||||
|
||||
You should be re-greasing the bearings at the same time. I do mine once a year, but guys that ride more frequently may do it it twice a year or more.
|
#3
|
||||
|
||||
Sure its worth it!
Remember your rear suspension will work to its full potential when every thing is periodically greased, same goes for your front end as well. The parts will come apart and go back together a lot easier by doing it regular also. 04 DE200 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Torquing Bolts | wbagwell | Enduro Engine - 2 stroke | 7 | 06-10-2014 07:36 AM |
how do you remove the kickstart | noobi | Enduro Chassis & Body | 13 | 09-22-2011 03:31 PM |
Remove front axle | BULTACOBRIS | General Discussions & Announcements | 2 | 03-10-2009 10:28 AM |
How best to remove carbon from PV components? | d2w | Enduro Engine - 2 stroke | 9 | 02-21-2008 09:03 PM |
What's the best way to remove the master link plate after it's pressed on? | MattR | Enduro Chassis & Body | 12 | 01-28-2007 12:15 PM |