#71
|
|||
|
|||
thank for the info if i dont get my jd kit by the week end i will raise the needle by 1 clip and try ,, i hope it will help with the poor gaz millage ..as i ride mostly wood so 1 and second gear and sometime 3th
cheer |
#72
|
||||
|
||||
Raise the clip one notch to lower the needle and allow less fuel.
__________________
Phil (New bike pending...) |
#73
|
||||
|
||||
Here's my pluglet.. for comparison. This has quite a few hours on it..
But really looking at a plug doesn't really tell you too much unless if you run it with a certain intent and know what you're looking at. |
#74
|
||||
|
||||
|
#75
|
|||
|
|||
Yes - That is my bike - it also has a Active Minds Engineering Route sheet holder on it as well. My son's bike is an older 2003 KTM EXC - and he has been bugging me about a newer bike with an electric start. My Yamaha wr450 and Christini are a bit heavy for him - so really need to shed the herd a bit and get him something more manageable.
I'm doing it with a lot of hesitation - because the Christini has been critical at the New England Classic kids ride when I'm helping with the kids get up the steep hills or out of mud holes. It's also a blast going through mud holes and riding in the snow. Lenny |
#76
|
|||
|
|||
That looks AWESOME !!
|
#77
|
|||
|
|||
I want that fuel tank and the rear rack ...let me know if you decide to part it out ...lol cheer
|
#78
|
|||
|
|||
I pulled it off Craigslist - really don't want to give up on this bike - it's just awesome in the mud, steep hill climbs, and snow.
Tonight - I changed the float height once again - from 7 to 9mm - still smokey at idle - but it's idling now. I put in the J&D Blue needle - clip 2 - Talk about a night and day difference between the red Clip4 and Blue #2. 1/4 throttle and the wheel comes right off the ground. I'm glad i have the throttle tamer on it. I have a 175 Main in it. Now I need to fill the tank and see what I get for Gas Mileage this weekend. I really don't want to lean it out anymore - because the power will become unsafe for me or my son in the woods. Thank you everyone - it's been a huge struggle... Lenny |
#79
|
|||
|
|||
ok no jd kit yet so i decide to pull carb out ,,, needle is n1ef clip 3 ( dead center) jet is 170 and the other is 42 ..going to raise it 1 clip and play with the float bowl ( raise it to 9 mm )
..by the way is that needle good or should i get another one ?? if so witch one should it be ? thanks Last edited by barbotte; 07-07-2017 at 04:14 PM. |
#80
|
|||
|
|||
From the little I know I think best results are from an n3_ _ or an ne_ _ needle range
I had the ktm n3eh and it was a bit more spunky than the nedw that I have now
__________________
2003 txt250 Pro 2013 Ossa 280i |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help with Float Level - Low mileage EC250 2013 | periclesgsilva | Enduro Intake/Carburetion - 2 stroke | 10 | 07-06-2017 05:22 PM |
2013 EC300 E - GasGas Fan Rectifier/Regulator | FDB | Enduro Electrical & Wiring | 2 | 10-25-2014 02:10 PM |
what ever happened with the 08 ec300 christini? | dank | General Discussions & Announcements | 14 | 04-26-2014 05:31 PM |
New 2013 Christini GasGas AWD 5999? | Moto7man | New Bikes | 16 | 02-24-2014 10:47 AM |
Christini Gasgas | 2 strokes 4 life | General Discussions & Announcements | 33 | 02-17-2009 11:22 AM |