|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2011 ec 300 stalling at low rpms with JD jet kit
hi guys.
2011 ec 300. brand new piston and rings. riding in victoria BC right now 20-25c at 0 to 1000 feet ASL. Started out with the shitty stock needle N1EF with a 178 main and 42 pilot. it ran ok in cold weather. but still not great. always stalled out at low rpms. I have a recluse clutch that may be affecting things I got a JD jet kit. I installed as per their directions. 40 PJ 180 MJ and red needle at clip #4. the bike idles better and the idle screw and air mix screw actually do something now. What hasnt changed is the fact that if i roll onto about 1/8 throttle then let off the gas as if to roll over a little bump the bike stalls. If i open up the throttle and continue to WOT the bike runs great. but i ride tight single track and i need good strong low RPMS Here are the combos of the JD jet kit that i have tried. with 180 MJ and 40 PJ ive tried Red needle clip #4 JD recommended start Blue needle clip #2 Blue needle clip #3 175 MJ 40 PJ Red#3 clip Red#2 clip i always start with the airscrew 1.5 out and go until 2.75 out. None of these combos seem to make a difference as far as preventing stalling the recluse seems to be set right bike tugs a tiny bit at idle in gear. any advice? has anyone had this problem? i cant keep crashing my bike because of stalling at these rpms, shes really starting to take a beating |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stalling at Idle | gassybill | Enduro Intake/Carburetion - 2 stroke | 6 | 07-03-2016 11:48 PM |
GasGas 300EC 2011 keep stalling without choke | smitten | Enduro Engine - 2 stroke | 8 | 08-08-2015 11:59 PM |
08 EC 300 Stalling when hot | MikeS | Enduro Intake/Carburetion - 2 stroke | 6 | 02-23-2014 12:17 AM |
closed petcock= highly elevated rpms? | hannesd | Enduro Intake/Carburetion - 2 stroke | 5 | 01-22-2014 03:31 PM |
'06 MC65 bogged acceleration from low RPMs | cajones007 | Mini Gasser 's Corner | 6 | 03-31-2010 05:35 AM |