|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Head Gasket/O-ring replacement-anything special?
It appears that I may need to replace my O-ring on the head, I am getting a little bit of oil/residue in my radiators. A small amount of oil has begun to appear floating atop the coolant and after draining/replacing the coolant it has reappeared (I think I have eliminated the possibility of it being left-over lubricant from the factory). Tranny oil is fine.
I have the O-ring and although I have replaced many top-ends I have just returned from the 4T world so it has been a while since I have torn into a 2T engine. Anything special I should know about when removing/reinstalling a GG head? Thanks 2010 300 40 hrs J
__________________
2015 KTM 450 XCW 2014 350 XCF Wife's 2009 200 ec. Loving it 2007 Beta Rev 3 270 2007 KTM 200 XC Wife's Public Lands belong to the Public |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
97 blew the head gasket? | Cruiser | General Discussions & Announcements | 11 | 08-08-2011 09:40 PM |
Head o ring | Dude | Enduro Engine - 2 stroke | 0 | 05-21-2011 09:28 AM |
Cylinder head o-ring question | Cruiser | Enduro Engine - 2 stroke | 4 | 04-14-2011 08:58 AM |
2006 EC250 Clutch Cover Gasket Replacement | Niloz | Enduro Engine - 2 stroke | 2 | 11-29-2010 05:44 PM |
Head-gasket O-Ring question | FFRDave | Enduro Engine - 2 stroke | 5 | 01-12-2008 09:56 AM |