|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
| View Poll Results: To bigbore or not to bigbore? | |||
| Hell yeah...make that puppy BARK! |
   
|
8 | 80.00% |
| Are you kidding, it already shoots me into the trees too fast as it is. |
  
|
2 | 20.00% |
| Voters: 10. You may not vote on this poll | |||
 |
|
|
Thread Tools | Display Modes |
|
#21
02-08-2008, 08:49 PM
|
||||
|
||||
Speedy. There's something funny about all of this that does'nt fit right. If your at 4 thou, and from the picture it looks like you have enough material to get an accurate measurment, your way past the service limit. To get a siezure like that on something that loose doesn't make sense. How many hours would you say is on that piston?
|
|
#22
02-12-2008, 04:31 PM
|
||||
|
||||
|
Not many. 10 hours tops. I put the piston in, shipped it to Chile, broke it in, did some testing, then rode from 9:47am to just before 5pm on day 1 when it seized. I'll measure again at the skirt and see what I get for piston/cylinder clearance.
Last edited by SpeedyManiac; 02-12-2008 at 05:08 PM.
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ISDE Photos up | gasgasman | Pictures & Videos | 3 | 10-12-2009 11:15 AM |
| Isde 2010 | roostafish | Off Road Racer's Corner | 10 | 12-10-2008 12:53 PM |
| ISDE fundraising | roostafish | General Discussions & Announcements | 2 | 01-20-2008 08:50 PM |
| 2010 Isde | roostafish | General Discussions & Announcements | 13 | 01-20-2008 08:18 PM |
| Isde Pic's | J.D. | General Discussions & Announcements | 0 | 11-13-2007 10:51 AM |
Linear Mode
