|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
More ec 200 problems
Well I thought it was fixed but guess not it will start up and run for about 5 min then it quits like it runs out of fuel but it quits getting spark I let it set for a few minutes (less than 5) and it gets spark again and will run for 5 more minutes or less where to start stator coil cdi ecu or just wires I'm lost when it comes to this kind of problem thanks for any help
|
#2
|
|||
|
|||
Breater in the gas cap is blocked. Mine did the same
|
#3
|
|||
|
|||
Sorry did not se the misding spark thing, could i be the ignition coil, when broken they usualy fail when getting hot.
|
#4
|
||||
|
||||
The ignition coil is what the spark plug wire comes from right I no its probe a stupid question but I've looked at so many things I think I've confused myself thanks
|
#5
|
||||
|
||||
ec200 problems
Also another dumb question are the ignition coils bike specific can I try on off of one of my other bikes they look the same
|
#6
|
|||
|
|||
It is :-) if you got some freeze in a can you can give it a spray, compresed air i a can turned up side down should do the trick as well. Stupid fault to find.
|
#7
|
|||
|
|||
check the kill switch, I had to solder it back together on the bars at one point, maybe its acting up, it never did for me though
__________________
Jack - western PA 2006 KTM 250 sx 2006 EC 200/ 11' style kit--GONE 2004 200 EXC 1997 KDX 220 2004 CRF 250X 1974 CL125 www.youtube.com/allthatstuff35 <---some gasgas videos here |
#8
|
||||
|
||||
ec200
Thanks ill check there as well I'm in the process of checking resistance on everything and tracing all wires ill keep everyone informed
|
#9
|
|||
|
|||
also check the yellow wire by the top shock mount on the left side if sitting on the bike, I remember it becoming exposed at one point and I covered it with electrical tape but that may have fallen off now causing a short?
__________________
Jack - western PA 2006 KTM 250 sx 2006 EC 200/ 11' style kit--GONE 2004 200 EXC 1997 KDX 220 2004 CRF 250X 1974 CL125 www.youtube.com/allthatstuff35 <---some gasgas videos here |
#10
|
||||
|
||||
ec200
Ok thanks I'm trying everything never had anything like this happen some are saying its the stator but in my experience when there bad there bad but I could be wrong ill try that wire as well thanks any other advice is welcome
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
yet more problems | bonkeye | Enduro Electrical & Wiring | 9 | 08-17-2013 09:48 AM |
Shifting Problems | jyellard | Enduro Engine - 2 stroke | 2 | 05-18-2009 05:05 AM |
CDI connection problems. HELP!!! | ejas66 | Enduro Electrical & Wiring | 4 | 02-18-2009 03:16 AM |
03 300 Problems | Ryan#87 | Enduro Engine - 2 stroke | 3 | 06-15-2008 10:28 AM |
06' ec 200 problems | speed addic | Enduro Engine - 2 stroke | 0 | 02-25-2007 06:44 PM |