|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cylinder Base nuts
Hi Guys.
I've searched and found hints but can someone explain exactally how I tighten up the nuts on the base of the cylinder or point me to the right post? What I have read suggests that they are 13mm nuts but mine are 14mm (1998 250). Is that correct? Fiche just lists as M10. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2010 300 Cylinder Base Gasket Question | coopernicus | Enduro Engine - 2 stroke | 12 | 06-22-2011 09:31 PM |
torquing cylinder base nuts.... | stainlesscycle | Enduro Engine - 2 stroke | 17 | 03-08-2010 06:42 AM |
Front brakes driving me nuts | brains | Enduro Chassis & Body | 11 | 07-03-2009 03:49 PM |
'05 seat base | Loosenut | General Discussions & Announcements | 0 | 07-11-2008 12:02 PM |
Base gasket | Ud_luz | Enduro Engine - 2 stroke | 21 | 05-09-2008 07:38 AM |