|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Did I catch my cylinder in time?
Last time I parted the top end on my gasser I noticed the plating was near the end of its life and compression was terrible so I set away sourcing a replacement cylinder.
Found one on here so once it arrived I pulled the top end and my god I think I caught it just in time before something expensive happened. Although I knew the cylinder was worn I had no option but to use it on a daily basis just for work but your talking 3 miles a day, prob could walk it but at 5.30am it's not something I would like to do. |
#2
|
|||
|
|||
There are places all around cylinder that have no nikasil, piston and rings are both fine
|
#3
|
||||
|
||||
Nasty! ! Good luck with that
|
#4
|
|||
|
|||
You should be able to get that replated OK. They repair worse damage all the time.
__________________
2011 EC250E |
#5
|
|||
|
|||
yep just had mine plated at powerseal usa and im putting it together today!!!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Run time | seb421 | Enduro Engine - 2 stroke | 2 | 06-27-2014 05:37 PM |
Time to say hello. | myoung | General Discussions & Announcements | 2 | 05-11-2014 07:47 AM |
It's Almosta Time again!! | Fred1956 | General Discussions & Announcements | 9 | 01-04-2014 10:24 AM |
Hammer Run Time | GMP | NorthEast United States | 39 | 11-12-2012 06:02 PM |
Your first time? | TooFastTim | General Discussions & Announcements | 23 | 02-17-2008 06:29 PM |