Power valve issue

[Noobi06]

Hi, My power valve assembly on my GasGas Ec 125 2006 is all right. Ive went over the manual multiple times and it is as it should.
When I attach the governer arm or what its called to the arm that actually raises the power valves, it gets stuck when I go to tighten it.
If I tighten it a very tiny bit, it is hard to raise the valves.
If I tighten it to a torque that feels legit to me so it doesnt vibrate loose, the power valve doesnt move at all. Im not able to raise the arm.
Why is this, im confused? I popped of the cover when the gasser was on and when I give gas, it doesnt budge. This was in neutral gear however. Im not sure if they open in neutral but I suppose they do? Or is it different when ur actually in gear?
Thanks a lot guys

[(F5)]

In gear or not won't make any difference.

On the bigger bikes there is a bent piece of wire that moves vertical to raise the lever. It has a stepped bolt on the triangular plate that the valve attaches to.

Is it the same arrangement? They use a nylock nut you have to burn plastic out or it can break this bolt then use a new one, available at hardware store.

[cbutler]

Get a new nylock nut and put it on but do not tighten it up against the actuator arm the nut will not move.