|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
'01 XC300 Power Valve in backwards
Hi, Wondering if its possible to put the power valve in backwards. I just did a top end rebuild and bike runs ok on the bottom and mid but chokes out from 5/8 to full throttle. I took the pipe off and the power valve cover linkage side off. It was all hooked up and works but then I realized that its wide open with the bike not running. If I manual rotate linkage it closes and when I let go of it the power valve springs open. I would have thought the none running position would be closed to increase the low end compression. Please help.
Thanks, Tim |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
power valve vent ? | walker1008 | Enduro Engine - 2 stroke | 6 | 01-14-2010 08:36 PM |
Power valve maintenance? | EricP | Enduro Engine - 2 stroke | 2 | 11-20-2008 04:46 PM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |
Power Valve rebuild | Gas Stu | Enduro Engine - 2 stroke | 2 | 09-19-2007 12:38 AM |
Power Valve Dilemma | gasIdaho | Enduro Engine - 2 stroke | 5 | 08-18-2007 03:06 PM |