|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Finally pulled the trigger
New to me 2011 300ec. I'm pretty pumped. Haven't rode a dirt bike since 2004ish.
|
#2
|
||||
|
||||
nice work!What was the last bike you rode?
|
#3
|
|||
|
|||
It was an 89 cr250r. I loved that bike, the smell and the sound.
|
#4
|
||||
|
||||
Good for you man!
You're going to love riding an enduro 2T Post up a ride report once you're able to get her out in the elements |
#5
|
|||
|
|||
You will love the bike! Make sure that you tighten your kickstand bolts and get a longer throttle cable(and safety wire it at the carb). I love my 2011 and I just bought a 94 CR 250 to restore.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#6
|
|||
|
|||
Why a longer throttle cable? Can you explain this more for me please?
|
#7
|
|||
|
|||
Just bought the same bike, 2011 EC300 a few months back. It had been about 10 yrs for me also. Love the bike! Rode 30 plus miles this weekend and the kickstand lost a bolt and the throttle cable slipped out at the carb. So definitely take the advise given. Great bike, have fun and enjoy!
http://youtu.be/WzE-6i7LU4E |
#8
|
||||
|
||||
Motion pro # 10-3000
__________________
'12 XC 200 TTX Sold '15 XC 250E Sale pending |
#9
|
|||
|
|||
After changing the fluids draining the old gas and going for a quick rip around the yard yesterday it seems the petcock fuel on/off/reserve is leaking a bit. Best just to order a replacement or is there a quick fix for this? Also should I go riding if it is leaking a bit?
|
#10
|
|||
|
|||
Petcocks are a very simple valve with usually just and o-ring or two inside to seal it. You should be able to pull it off (screws on the face), clean the seal surfaces and rings then put it back together. Unless the o-rings rotted for some reason that should do it.
Not too good an idea to ride with it leaking there, although hard to do it could turn your bike into a bonfire. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pulled PV to clean and now RPM REALLY high | SingleTrackMind | Enduro Engine - 2 stroke | 5 | 07-22-2013 06:10 AM |
Finally got my new ride | Jetster220 | General Discussions & Announcements | 12 | 10-09-2012 11:28 AM |
Finally!!! | rbm33 | General Discussions & Announcements | 3 | 09-29-2012 03:24 PM |
Choke will not stay pulled up | forgiven | General Discussions & Announcements | 10 | 09-05-2009 12:58 PM |
finally had a problem! | mountain thumper | General Discussions & Announcements | 1 | 04-11-2008 05:07 PM |