|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
The only difference I've found with engine oil is dragging when cold. After that, they all feel exactly the same. Only hot difference is squawking under heavy load. Thinner oils seem better as they must get into the plates easier, but under extreme heat are just as bad. I've solved all those problems with a decent basket, so in my mind oil is a plaster, not a solution.
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wanted!! Ec200 seat, radiators, switch gear, gear lever | Kendog | "Wanted to Buy" & "Want To Trade" | 2 | 10-12-2014 03:12 PM |
02 400 will not idle | jason r | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 11-18-2013 04:14 PM |
Bad idle | Madhead | Enduro Intake/Carburetion - 2 stroke | 1 | 08-11-2011 06:20 AM |
Does not idle or rev | Binni | Enduro Intake/Carburetion - 2 stroke | 8 | 02-14-2011 03:29 PM |
can,t get idle up | geno | Enduro Intake/Carburetion - 2 stroke | 1 | 04-18-2010 08:49 PM |