|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
2023 Rieju 300 factory jets.
I was surprised, a 170 and a 40 PJ.
I installed an NEDW but curious what I should jet at say 9,500' Thanks.
__________________
04 Montesa 315R, 07 EC300, 21 KTM Erzberg 300, 21 Sherco 300 SEF-F, 23 KTM 690, 23 Rieju Mr Pro 300 |
#2
|
|||
|
|||
Ud_luz, here are some reference points for you.
I posted this in ThumperTalk recently. I have a 18 EC300 126 hours, runs extremely well. Original piston, power valve has not been adjusted or cleaned. I am a senior rider & do not ride at full power very often. Motorex Cross Power 2T 50:1 I get lots of spooge. To me, this means the motor is getting good lubrication. I just wipe it off w/ a paper towel at the end of each ride. Riding in Colorado & Utah @ elevations 4,600' to 12,000'. Carb settings: Needle JD Red in 2nd position, Pilot Jet #48, Main Jet 162 Runs a little rich @ higher elevations but fine for me gez300 from Australia thought my Pilot jet was way too large. Its not. Hope this helps |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rieju Factory Parts Page | Moto7man | General Discussions & Announcements | 0 | 06-18-2023 09:34 AM |
New 2023 GasGas EC300 owner | DarkMatter | General Discussions & Announcements | 6 | 05-22-2023 09:30 PM |
Kyb fork issue 2018 and 2023 Help Please | Stoby | Enduro Suspension | 9 | 02-02-2023 10:09 AM |
2023 | Stoby | General Discussions & Announcements | 10 | 10-12-2022 03:04 AM |
DirtBike Magazine 2023 CRF 450 | Moto7man | Pictures & Videos | 0 | 08-03-2022 10:01 PM |