#11
|
|||
|
|||
How much throttle angle rotation is needed for wide open with a G2 400 cam compared to a stock 1/4 turn?
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
#12
|
||||
|
||||
Quote:
|
#13
|
|||
|
|||
The throttle cam will allow full throttle but it will take longer.
EDIT: Example: http://www.g2ergo.com/sitebody/howitworks.shtml |
#14
|
||||
|
||||
Quote:
|
#15
|
||||
|
||||
Quote:
The front end still lofts easily to get over obstacles. |
#16
|
|||
|
|||
I took a good careful look at the G2 websight, and found a .050 cam, but its only for 4 strokes.
I looked for an E-mail adress, so I could try to learn why the .050 can only be used for 4 strokes or if they are developing one for 2 strokes also. Any ideas ?? |
#17
|
|||
|
|||
Quote:
Sam@G2ergo.com - Founder Info@G2ergo.com - General Questions Tech@G2ergo.com - Installation & Technical issues AlphaBITSinc@Gmail.com - Website comments/questions |
#18
|
|||
|
|||
I modified the ramp on my son's RM65 throttle tube on a disk sander similar
to the G2. It helps him ride in the tight woods and slows down the hit. Cost me about 5min. during lunch break! Good Luck! |
#19
|
||||
|
||||
What it does is make the carb slide travel non-linear relative to the throttle rotation angle. The total rotation from closed to WFO is still the same. You have more resolution in control below half throttle with the 200 and 400 cams, but more than that quickly opens the slide to where it would be with the 100 cam (stock).
|
#20
|
|||
|
|||
did anyone else have a bit of a time getting the cable end into 400 cam. I had to unscrerw the top of the carb to get enough cable to pay out and it was still a pain in the arse. Did I miss something along the way?? Swapping out cams isn't something i would want to do a lot of.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Suspension or Mousse tube? | wence | Enduro Chassis & Body | 9 | 07-28-2010 07:40 AM |
GasGas now in you tube | Leo | Pictures & Videos | 3 | 01-24-2010 04:59 AM |
Tube troubles! Need help. | svt2224 | Enduro Chassis & Body | 19 | 10-12-2008 07:50 PM |
FSE400 throttle tube | nitroman | Enduro Chassis & Body | 0 | 12-22-2007 05:17 AM |
fork tube play | skid jackson | Enduro Suspension | 2 | 09-14-2007 05:47 AM |