GasGas Riders Club Forum  

Go Back   GasGas Riders Club Forum > GasGas Trials Technical Forums > Trials Engine

Trials Engine Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 10-02-2021, 09:01 AM
vaughan vaughan is offline
Member
 
Join Date: Sep 2021
Posts: 2
Question Clutch shim?

Hi, i am replacing the clutch plates in my GAS GAS 300 txt, year is between 2010-2014... there is a spacer between the clutch fingers and the needle bearing, my question is which side of the spacer does the shim sit? i took it off between the fingers and the spacer but it doesnt seem right? Was wondering if anybody had a parts diagram? Thanks in advance.
Reply With Quote
 



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
2018 KYB shim stacks Gibnut Enduro Suspension 18 05-18-2018 01:08 PM
Sachs shim 7ID & 9ID, where I can buy? dewenduro Enduro Suspension 11 08-15-2016 03:34 PM
Marzocchi 45 shim advice? motopsycho87 Enduro Suspension 17 10-20-2014 01:47 PM
Countershaft sprocket shim 3hunerd Enduro Engine - 2 stroke 5 03-24-2012 10:29 AM
45mm zoke shim id Ed Ventura Enduro Suspension 1 09-22-2008 06:34 AM




All times are GMT -5. The time now is 03:43 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org