|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
07-28-2010, 02:11 PM
|
||||
|
||||
Loose Airscrew
I was messing with the carb on the 04 200 today, and noticed that when I went to adjust the airscrew again after riding it had vibrated shut, I set it 1.5 turns out rode again for ten minutes or so and it vibrated shut again.
I guess I need to get a new one , but I thought it was odd. Has this ever happened to anybody here before? THe bad thing is now I might have to start over unless my settings that I have now will work when I get a airscrew that will stay set. 
|
|
#2
07-28-2010, 03:04 PM
|
||||
|
||||
|
there is supposed to be a spring that keeps the screw where you put it..... is the spring still there?
__________________
03 ec250 hyde skidplate, cycra handguads, protaper contours "what? it seemed like a good idea at the time!"
|
|
#3
07-28-2010, 04:39 PM
|
||||
|
||||
|
No,the spring is gone. I just looked @ the exploded picture and saw that there is supposed to be a spring.
THe bad thing is ,I may have to start over on my testing unless the last set up is the right one by chance. Last edited by biggstr6; 07-29-2010 at 04:58 AM.
|
|
#4
07-28-2010, 06:39 PM
|
||||
|
||||
|
like a set screw? i know its supposed to be an air screw, but theres a spring around it that should hold it from moving. is that spring shot maybe?
__________________
03 ec250 hyde skidplate, cycra handguads, protaper contours "what? it seemed like a good idea at the time!"
|
|
#6
07-29-2010, 08:40 AM
|
||||
|
||||
|
Correct Dank , I didnt type a clear reply . (i fixed the reply so it sounds right).
|
|
#7
07-29-2010, 09:07 AM
|
||||
|
||||
|
ok gotcha. well good luck. i would think that if it ran well when you would set the screw, then you shouldnt need to change too much at least.
__________________
03 ec250 hyde skidplate, cycra handguads, protaper contours "what? it seemed like a good idea at the time!"
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| loose bottom marzocchi cap | noobi | Enduro Suspension | 2 | 06-06-2010 07:48 PM |
| Loose yellow wire in airbox | stevethebrit | Enduro Electrical & Wiring | 2 | 09-30-2009 04:40 PM |
| Loose Moose Enduro Results - GG Riders! | MattR | General Discussions & Announcements | 0 | 06-19-2008 07:02 PM |
| All hell's broken loose in the trials world.. | TooFastTim | General Discussions & Announcements | 27 | 09-10-2007 11:55 AM |
Linear Mode
