|
|
|||||||
| Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
|
Thread Tools | Display Modes |
|
#1
10-06-2013, 03:19 PM
|
||||
|
||||
2013 Rear Linkage pulls off center? Is this normal? sort of a WTF moment!!
I just am able to use my arm enough to being putting things back together. tore it down before shoulder surgery and noticed that the washers seemed to be wearing off-center. I just inspected the pulls and darned if they are not machined oblong - is this normal? It sure allowed a lot of crap to get into the bearings and screw up the seals. I have a set of the scorpion pulls that are going back on to protect the lower shock.
Also, do I just punch the old seals out from the opposite side?
__________________
Rob Granger / Katy, TX EC300 Breaking more things by 8:00AM than most people break all day. Last edited by rgranger; 10-07-2013 at 01:15 AM. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Linkage Needle Bearings | StuJohnson | Enduro Suspension | 14 | 02-06-2013 04:59 PM |
| '12 Rear Suspension Linkage Bushing/Shaft/Axle | TBUBBA | Enduro Suspension | 2 | 02-04-2013 02:45 PM |
| wear in rear linkage HELP | kyle | Enduro Suspension | 10 | 03-14-2011 10:33 AM |
| Rear linkage brackets lower mount | 3hunerd | Enduro Suspension | 2 | 10-16-2008 09:42 AM |
| Zerks for rear linkage? | mike989 | Enduro Suspension | 7 | 06-17-2007 06:50 PM |
Threaded Mode