|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
250/300 gearing
Hi guys i have a 2019 ec 250 but i belive it was a 300 and the importer changed the barrel and piston to make it a 250 as there were non left when i wanted one.
Its a brill bike but it feels like theres a big hole in the gearing just before the power valve opens, not like my 2018 250?? I have not played with the pv yet i will this weekend, but my question is are the gearbox ratios the same?? |
#2
|
||||
|
||||
What gearing did you run on the old one? Did they change the CDI as well?
|
#3
|
|||
|
|||
Throw the stock 48 tooth sprocket in the bin and get a 50. Or if you don’t want to buy a new chain and rear sprocket, just throw a 12 tooth on the front for now. Also set the PV at 1.5 turns out as a baseline. Pull the stock needle out of the carb and bury it somewhere so it can never be found and go with a N3CH or NEDW/NEDJ needle.
Sent from my iPhone using Tapatalk |
#4
|
|||
|
|||
Hi memphis its got the suzuki nesle in it and 13/50 sprockets same as my old 250, i assume they did the ecu as it was the main importer who did the swap.
Just dont feel the same but i have not touched the PV yet, guess i will do that and see how it feels 👍 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2018 XC 250 Gearing | J. JuJu | Enduro Chassis & Body | 2 | 08-27-2018 10:14 PM |
FSE gearing | spencergt66 | Enduro Chassis & Body | 1 | 07-11-2016 01:40 AM |
200 gearing | dirtyDsun | General Discussions & Announcements | 6 | 06-05-2015 11:32 PM |
250 gearing | skid jackson | Enduro Chassis & Body | 12 | 10-17-2011 08:23 AM |
Gearing down an XC 300 | Krieg | General Discussions & Announcements | 15 | 01-29-2011 10:03 PM |