|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
43 mm wp forks.
so i am finally going to have to put fork seals in my 01 300 with wp forks..
anything thing wierd on those forks to watch out for.. just wondering. thanks in advance jay
__________________
broken down over 60 slow rider.. |
#2
|
||||
|
||||
Super easy. I did mine yesterday with a cast on my right wrist (and I am right handed). 43mm seal driver and a thin 21mm wrench (i think) and you're golden. If you've changed a fork seal on an USD fork, you'll have no problem.
|
#3
|
||||
|
||||
Quote:
i ordered seals and a driver today.. dont have one that small yet.. thank you..
__________________
broken down over 60 slow rider.. |
#4
|
||||
|
||||
While the cartridges are out, you might want to inspect the midvalve/checkplate shims. If the stock valving was changed it may have a lighter shim setup in there, which means more stress on the shims in this fork. The face shim gets beat due to the high flow through the piston, first cup and then crack. Easy to do. Just unscrew the plastic spring guide and the damper rod assy will drop out the bottom of the cartridge.
|
#5
|
||||
|
||||
Quote:
__________________
broken down over 60 slow rider.. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
forks | sen480 | General Discussions & Announcements | 1 | 03-25-2010 04:54 AM |
which forks have i got?! | tommo | Enduro Suspension | 3 | 12-29-2009 02:53 PM |
EC250 Forks??? | darren | United Kingdom | 18 | 02-17-2009 02:02 PM |
Offroad forks | PEB | General Discussions & Announcements | 5 | 09-12-2008 02:45 PM |