#11
|
||||
|
||||
Understood. I imagine it is chilly in Sweden right now. I am near Chicago and it is not too bad here at 0C and we do not have any snow right now.
|
#13
|
|||
|
|||
i think that is the breather connection for the left powervalve cover
__________________
2003 txt250 Pro 2013 Ossa 280i |
#14
|
|||
|
|||
Uhm, okeyy. Never heard about it, its on a 125. I dont think i need to do anything I suppose
|
#15
|
||||
|
||||
Put a hose on it. If it is on the top of the power valve run the hose up an then down. If it is on the bottom of the power valve area, run the hose down as a drain.
|
#16
|
|||
|
|||
you can see the hose attached to the frame on this photo
https://upload.wikimedia.org/wikiped...C_125_2006.JPG
__________________
2003 txt250 Pro 2013 Ossa 280i |
#17
|
|||
|
|||
So I just take any hose and run it down?
|
#18
|
|||
|
|||
yes. it normally just drips out exhaust spooge.
from the factory it used to come folded over and ziptied with the possible intention that you would release it and allow the spooge to drain out into a container and dispose of it responsibly rather than dripping it all over the country side, but not sure if that works in reality
__________________
2003 txt250 Pro 2013 Ossa 280i |
#19
|
|||
|
|||
Bore
This is the pistons highest point. Is this causing low compression? Or is my piston ring possibly worn? Should I use a thinner gasket? I have the thickest or one of the thickest.
IMG_3969.jpg Last edited by Noobi06; 02-05-2023 at 03:52 PM. |
#20
|
|||
|
|||
What about this?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My starter works great now! | Bobt250 | Enduro Electrical & Wiring | 114 | 08-16-2020 11:38 AM |
Is there a TUNE ECU app that works ? | Mikesbaron | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 08-29-2019 03:55 PM |
Anybody have an 02/03 450 FSE that actually works ? | wakeymatt | General Discussions & Announcements | 5 | 08-09-2012 06:07 AM |
Does anyone know how the compression release works? | stay_upright | Enduro Engine - 2 stroke | 1 | 07-24-2009 10:37 AM |
300xc what gearing works best?? | Dingoe | Enduro Chassis & Body | 6 | 02-05-2007 03:47 PM |