|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
 |
|
|
Thread Tools | Display Modes |
|
#1
03-01-2010, 02:22 PM
|
|||
|
|||
Gas tank shroud
The plastic insert that holds on the tank shroud pulled out. I was wondering what you guys have done to fix this. It's not just the screw it's self it is the hole plastic inserts. I am not able to get it back in due to the shape.
|
|
#2
03-01-2010, 03:26 PM
|
||||
|
||||
|
Filled the hole with a black epoxy resin, drilled a small hole to guide the self tapper and away you go again.
For the tanks with the nut in, put a small amount of resin in the hole reset the nut and wait to set.
__________________
02 300ec- 50mm Marzocchi cc forks, 2010 plastic. Now a 250cc.
|
|
#3
03-01-2010, 03:47 PM
|
||||
|
||||
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| seized shroud screw in Clark oversize tank | jostby | General Discussions & Announcements | 6 | 12-13-2009 02:49 PM |
| Shroud / tank repair | Brian VT | Enduro Chassis & Body | 1 | 07-05-2008 02:31 PM |
Linear Mode
