|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
GAS GAS Trailtech Vapor Speedometer sensors
Hello everyone
I got a GG EC 250 2011 and there ' s a Trailtech Vapor on it. But the cables are cut off. And there are no sensors...I need help to identify the cables coming out of speedo. I know which pair is the Power. The engines temperature sensor has 4 wires? Can I replace this sensor with an other except Trailtech's because I think is too expensive? Is there a cable that goes to spark plug? I need any info that you can give. Thanks a lot |
#2
|
|||
|
|||
After contact with TrailTech I finally found out the answer. So I'll try to put some infos here in case someone else need this.
The speedometer |
#3
|
|||
|
|||
The first cable from the left with the connector is connected to Power 12v. The second is for tachometer sensor. The third, which is red marked, is a 4 wire cable that is connected to remote switch (which is no longer available). The last cable is for engine temp sensor.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2007 Ec 300 speedometer | Jonas300 | Enduro Electrical & Wiring | 4 | 04-29-2018 03:12 PM |
2011 xc 300 odo/speedometer ? | Muddy | General Discussions & Announcements | 48 | 07-22-2013 10:38 AM |
Wanted: Enduro Computer (Trailtech/Vapor). Lots Of Bike Parts To Trade. | flatout111 | "Wanted to Buy" & "Want To Trade" | 3 | 04-21-2013 08:32 AM |
Problem with Trailtech Vapor on 2011-EC300e | erniebearskin | Enduro Electrical & Wiring | 2 | 05-20-2012 08:53 AM |
Vapor Trailtech | darren | United Kingdom | 8 | 07-22-2009 01:05 PM |