|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
How to set float level. Revisited.
A while back, I posted a link on how to set your float level.
I finally found it after a long search. Here it is again for those that need to have their's reset.. http://www.dirtridersinternational.c...?TOPIC_ID=2292 Last edited by gasgasman; 08-25-2007 at 09:08 PM. |
#2
|
||||
|
||||
For some reason the photos won't come up.
Here they are in the order that they appear in the instructions. (Float assembly pivot pin not shown.) (Fuel inlet needle shown with Viton (rubber) tip. The Viton is used to isolate the fuel inlet needle from vibration and to create a better seal against the fuel inlet valve seat.) |
#3
|
|||
|
|||
The first link no longer works.
I have checked and adjusted float level on other carbs, so could someone post some basic instructions with dimensions? Thanks, Josh |
#4
|
||||
|
||||
Try this http://www.keihin-us.com/am/_media/pdf/slide_valve.pdf
Float height is mentioned on the right.
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#5
|
|||
|
|||
Quote:
of the float as shown in the picture. |
#6
|
|||
|
|||
help on float height
Hi can anyone advise me on the correct float height for my year 2000 ec 300.
|
#7
|
||||
|
||||
16mm to the best of my knowledge.
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
#8
|
||||
|
||||
Hey guys, any chance someone has pics showing this? None of the links work and the old pics are no longer there. Need some help as the 250 is pissing fuel out the vent tube when the fuel is on.
Not sure where to measure float height from? |
#9
|
||||
|
||||
External Link
If the level is right and its still overflowing double check the viton tip on the float needle. Sometimes they perish, othertimes they just have a bit of grit stopping it from sealing. |
#10
|
||||
|
||||
I just fixed the float level on a kdx last week where the factory specs werent right for that carb because the needle valve seat needed to be altered. Long story short I made a fuel level guage out of tubing and a stopper. The gas goes up the tube to about 2 mm below the mating seam of the carb bowl.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC300 Idle Revisited. | Ud_luz | Enduro Intake/Carburetion - 2 stroke | 35 | 01-07-2011 07:39 PM |
Rear wheel spacers revisited. | Ud_luz | Enduro Chassis & Body | 9 | 09-13-2010 08:01 PM |
Zokes oil level? | jostby | Enduro Suspension | 2 | 06-20-2009 11:29 AM |
Fork oil level ? | Brian VT | Enduro Suspension | 4 | 03-10-2009 08:57 PM |
WP Fork Oil Level | MattR | Enduro Suspension | 11 | 08-02-2006 10:40 AM |