|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Thanks for the replies. I have ground the tack weld off the back of the plate and punched out the remains of the pin. I will just tack a bolt in place and make a bush to suit.
I had ordered the part from Scotties but he said he was unable to get the part from Gasgas. Hope the parts situation improves soon. Seems the new importer is only interested in moving new bikes. |
#12
|
||||
|
||||
Quote:
|
#13
|
|||
|
|||
I thought I had read somewhere that Jeff had sold the remaining stock to the new importer. I did order some parts from him when he was selling off stock at 50% off but I got in a little late and didn't get all that I ordered.
At this point i'm happy with fixing the old part, but if I doesn't work out I will contact Jeff. |
#14
|
||||
|
||||
I don't actually know what he's got left in stock.. but has to have at least a couple things. I had a few dollars credit remaining from the 50% clearance where I'd paid for bits that he'd run out of. He sent me something else I'd enquired about for Christmas.
Really just depends what he was holding and not. I don't imagine the 50% clearance would have had people jumping for actuator plates (but you never know); more likely just at the consumables and plastics, etc. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ec 300 power valve | Jonisaacson17 | Enduro Engine - 2 stroke | 11 | 07-18-2016 09:01 PM |
Loss of power - suspect power valve | Jonny Halls | Enduro Engine - 2 stroke | 4 | 01-22-2013 09:56 AM |
power valve nut | bonkeye | Enduro Engine - 2 stroke | 4 | 10-11-2012 06:40 PM |
Is this power valve lever plate wrong? | mark250ec | Enduro Engine - 2 stroke | 2 | 09-06-2011 05:39 PM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |