RB Designs carb work

[Eric K]

On my '01 XC300, I wore the LTR needle and I wore the carburetor nozzle (where the needle slides in the carb). The LTR needle wore about 0.0005” over 3 years. During this time the engine became overly rich, especially in the 1/8-1/4 throttle range. Compensating with a leaner needle was partially successful.

Since RB Designs now replaces nozzles, I had Ron replace the nozzle. With the new nozzle, it works great. If you have a lot of hours on your GasGas and your engine runs overly rich at low throttle openings, I strongly recommend you have RB Designs replace your carb nozzle.

Ron does top notch work!!