|
Parts New/Used Components and All Bike Part Outs |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
SOLD! Complete Clutch Assembly - 2011 SOLD!
Everything you see is included. This clutch was working fine when my Gasser decided to give up its ghost. No slippage. Just a minimal amount of drag when not completely warmed up. Included in this sale but not shown in the pictures are the springs with bolts, clutch rod, nut, and washer.
Full Disclosure- There is slight cosmetic damage on the back side of the outer basket and all parts need to be run through the washer to remove metal shavings due to the catastrophic failure that occurred elsewhere in my engine. This is a steal at $200 plus shipping! SOLD! Last edited by mcnut; 12-23-2014 at 09:03 AM. Reason: SOLD! |
#2
|
|||
|
|||
I'll take it! I'll send you a pm.
|
#3
|
||||
|
||||
Sale pending.
|
#4
|
|||
|
|||
Received the clutch today. Thanks so very much!
|
#5
|
||||
|
||||
You're welcome!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Complete Hydraulic Clutch Control System | mcnut | Parts | 10 | 12-03-2014 09:28 AM |
Ec300 clutch assembly position | jprizz | Enduro Engine - 2 stroke | 4 | 06-17-2014 06:01 PM |
Is clutch basket position critical on re-assembly | hillbilly | Enduro Engine - 2 stroke | 1 | 04-06-2012 07:32 AM |
2008 EC300 clutch assembly position | mwoody98 | Enduro Engine - 2 stroke | 0 | 03-13-2012 09:52 PM |
Looking for a clutch master cylinder assembly... | SpeedyManiac | General Discussions & Announcements | 5 | 05-09-2008 07:06 PM |