|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
07-22-2016, 03:32 AM
|
|||
|
|||
pv breather 2007 ec200
gday lads I'm setting up a ec200 and have never worked on a 2t I see the pv breather bolt or spigot was broken inside the hole after much much work got the broken thread out.. without removing engine from frame!!!
now I see it must be from factory the hose is folded and cable tied, and after much reading here (thanks again for the top site) it seems the consensus is to leave it open to breath... fair enough but I don't like the idea that even the remotest chance something may get up there ie dust water ive found this one way valve.... good idea or not?? http://www.ebay.com.au/itm/6mm-1-4-A...MAAOSw7ehXRU7V 
|
|
#3
07-22-2016, 06:20 AM
|
|||
|
|||
|
not a bad idea rb will be lookin for one now
|
|
#4
07-22-2016, 07:07 AM
|
|||
|
|||
|
got 2 of these for the breathers..
http://www.ebay.com.au/itm/231787619225 2 of these for the fuel will get a stainless elbow barb for inlet and a straight barb for outlet.. http://www.ebay.com.au/itm/401130886969 and some of this for obvious reasons I would think http://www.ebay.com.au/itm/200660066710 cheers for the top idea rb..
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2007 EC200 Hobby Questions.. | justinholmes10 | Enduro Engine - 2 stroke | 8 | 08-17-2015 04:07 AM |
| 2007 EC200 - CDI Pinout | Steve-A | Enduro Electrical & Wiring | 4 | 10-28-2014 04:50 PM |
| 2007 EC200 Northern VA $2500 | Front Royalty | Used Bikes | 14 | 05-11-2014 05:23 PM |
Linear Mode
