|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Chain & Sprocket Sizes
Just a quick question for all you knowledgable foke out there - I was wondering what it the standard chain and sprocket sizes for a 2003 Gas Gas EC 300, plus was there any changes to the 2007 model, i.e. does the stuff for the 2007 model fit directly on the 2003 model??
|
#2
|
||||
|
||||
Quote:
13-48 is standard. Yes, sprockets have been the same since forever. |
#3
|
|||
|
|||
Thanks for that, one final question: how many links are needed in the chain??
|
#4
|
||||
|
||||
Quote:
However, iirc a 120 link chain with a few taken out is good. |
#5
|
|||
|
|||
Yea, I figured 120 should be more than enough. Thanks again...
|
#6
|
|||
|
|||
Right I've had Supermoto wheels fitted to my Gasser for the last few months and was going to put the knobbles back on and was looking for a new chain and sprocket for the rear.
Anyway I was looking on the net for a good deal on the bits I need and there is a guy offering a chain 110 links long, so I counted the links on the old chain and its 112 including the split link. So I was wondering if 110 would fit or would it be too short?? The set up is 13 front and 48 rear. |
#7
|
|||
|
|||
I run 114 links with 13/50 sprockets to get the rear axle back further.
Look at where the axle sits with a good 112 link chain. If you can move the axle 0.625 in forward then you could probably fit the 110 link chain. I personally don't think it would fit.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
#8
|
||||
|
||||
Even if it did fit(close), it would cause the tire to chew up the mudguard of tear it off if a rock got in there.
|
#9
|
||||
|
||||
Glenn is right - just running a 13/50 combo with a trials tire and stock chain wile eat up the mudguard.
|
#10
|
|||
|
|||
I see a good few riders go up a few teeth on the rear and I was thinking of doing the same as I never get out of the lower gears.
How much difference would a 50 T rear sprocket make?? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Chain & Sprocket Website | swazi_matt | Enduro Chassis & Body | 2 | 06-13-2012 09:30 AM |
sprocket change will I need a new chain? | chucky | Enduro Chassis & Body | 13 | 06-08-2010 09:56 AM |
chain slider / chain guide crossover? | bondo | General Discussions & Announcements | 1 | 09-01-2008 09:13 PM |
EC Chain/Sprocket Suggestions? | cdn280 | General Discussions & Announcements | 10 | 07-31-2008 02:22 PM |
Chain and Sprocket specs | gasIdaho | Enduro Chassis & Body | 7 | 09-01-2006 04:03 AM |