|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
custom coolant recovery tank
Here's a cheap and easy to make coolant recovery tank.
You can use any diameter or length pipe to suite your needs. I used 1-1/2" pvc pipe 2) 1-1/2'' id end caps clear tubing 2) npt barbed ends and some thread tape Cut the pipe to length...you need drill a hole in the center of both end caps tap threads into the cap, I used a flare tap, and tapped so that the barbed fitting fits tight into the first couple of threads...that way you get a tight seal tape the threads of the fittings and tighten them into the caps use pvc glue and spread a thin layer into the ends of the pipe and assemble the caps into place. Let the glue set for a while and attach to the bike. The bottom tank fitting connects to the radiator over flow nipple just under the cap, the top tank fitting is a vent, that should route some where below the engine. add a little coolant to the tank, that's it. I got the pvc pipe free, I already had a tap and tape, so all I had to buy was the end caps, I spent about $5.00 on the whole thing. [IMG] [IMG][/IMG] |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Coolant and 1.8 bar cap? | wence | Enduro Engine - 2 stroke | 8 | 03-11-2010 09:31 PM |
Co. that make custom # plate backgrounds | REVERUP | General Discussions & Announcements | 6 | 12-15-2009 06:08 PM |
Custom Number Graphics | Roy Salmon | General Discussions & Announcements | 2 | 01-02-2007 06:34 PM |
Coolant | FFRDave | Enduro Engine - 2 stroke | 33 | 09-13-2006 08:24 PM |
Add "Injury/Recovery" section??? | MattR | GasGas Member Polls | 1 | 07-19-2006 08:02 PM |