|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
pv actuator shaft broken help plz
that little shaft that comes off the triangle part under the rh pv cover has broken off. this happened while riding and i found it by accident, pv is still working because the end of the shaft is still sitting in the hole. i have always been suspicous that it has had too much preload on it as you could hear the pv quite loudly with a quick blip of the throttle at the right rpm. i wasnt broken when i done the topend 20hrs ago although that is probly why its broken i would have weaknd it as everyone nows that are weak
Anyway how do i get the nut off the spline now, i have tryed heating the nut and trying to hold the back of the shaft with pliers (had to give it a go) to no avail, hopefully i dont have to strip it down any help appreciated
__________________
06 EC250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Balance shaft removal. | darren | Enduro Engine - 2 stroke | 3 | 11-15-2009 05:18 PM |
Waterpump shaft end play | SpeedyManiac | Enduro Engine - 2 stroke | 1 | 04-08-2009 09:05 AM |
swing arm shaft stuck | whodat | Enduro Chassis & Body | 17 | 03-22-2009 07:53 AM |
Kickstart shaft question | GMP | Enduro Engine - 2 stroke | 6 | 02-22-2009 02:55 PM |
Broken Kickstarter shaft | JCW | Enduro Engine - 2 stroke | 8 | 12-07-2007 08:31 AM |