|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
gg250f loss of power question
OK here is the deal
I have a 2011 GasGas 250f which is an enduro with a 2006 wr250f motor. It doesn't have a grey wire or the other restriction stuff. I bought it used and seemed to be low on power. I put an 06yz250f piston in and no change, and the old one was fine, put in yz exhaust cam very little change. Megabomb header and 4.1 slipon and NOTHING like my other bikes. I have a 2006 yz250f with a flywheel weight which is a beast. I have a 2013 yz250f which is also a beast. Both are stock minus an exhaust on the 2006 but the 2013 is completely stock. Any ideas where to look. It does ok on level ground but under a load like a hill it shows its lack of power. Air filter is clean, oil is new. I am at an absolute loss. IF I could get electric start and power similiar to my 06 yzf this might be the best bike ever made by man so please help. |
#2
|
||||
|
||||
Ignition timing/CDI? Head?
|
#3
|
|||
|
|||
What would I check on the CDI or head?
|
#4
|
||||
|
||||
Head - Valve clearances/sealing
CDI - No idea how you'd check it short of swapping it for another. Is it the same as the ones on the Yamahas? Maybe.. Have you done a leak down test on it at any point? Is it possible that the engines making power but not getting it to the wheels? ie slipping clutch/heavy rear tyre & chain/flywheel mass? Whats the tune like? Are you running the same needle/jet combo across all 3 bikes? |
#5
|
|||
|
|||
Had the valves shimmed up with the new piston. Haven't done a leak down check though. I don't have any clue on the jetting mostly because there is a quick shot on there and don't know much about them.
I would assume it is a wr cdi but I don't know that. Will have to check before I try. It would be nice to put a yz250f one in but I am sure I am not that lucky. Good stuff. I have to unload today from my 4 day Missouri trip and hopefully start later today. Last edited by forgiven; 10-21-2013 at 09:26 AM. |
#6
|
||||
|
||||
Any chance you can swap the carbs over?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Loss of power - suspect power valve | Jonny Halls | Enduro Engine - 2 stroke | 4 | 01-22-2013 09:56 AM |
EC 300 Rattling & power loss ??? | Porkyblader | Enduro Engine - 2 stroke | 7 | 09-09-2011 09:11 AM |
Your 300 Power loss solution? | socalscott | Enduro Engine - 2 stroke | 3 | 07-14-2011 08:39 PM |
Old gas and power loss? | EcEvan03 | General Discussions & Announcements | 16 | 04-27-2011 06:40 PM |
power loss | glassman581 | Enduro Intake/Carburetion - 2 stroke | 3 | 03-22-2011 11:19 AM |