|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
power valve 2006 on 2013 cylinder
has somebody used a the power valve system from 2006 on the 2013.
i bought a athena cylinder for 2013-2015 and thought that it was possible to put in the 2006 powervalve. but now i see that its not possible because it doesnt open all the was and hits the cover when its fully opened. i thinking of make an spacer so the power valves can go out longer and cut a little where the axis goes so the powervalves is able to open all the way somebody done this? |
Tags |
ec 125, ec125, power valve |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
power valve ec 125 2013 | eranmu | Enduro Engine - 2 stroke | 6 | 04-19-2017 07:08 AM |
Power Valve ? | BigAl | Enduro Engine - 2 stroke | 4 | 01-05-2015 09:08 PM |
S3 cylinder/power valve help? | '11EC300 | Enduro Engine - 2 stroke | 7 | 06-02-2014 08:18 PM |
Loss of power - suspect power valve | Jonny Halls | Enduro Engine - 2 stroke | 4 | 01-22-2013 09:56 AM |
power valve nut | bonkeye | Enduro Engine - 2 stroke | 4 | 10-11-2012 06:40 PM |