#11
|
||||
|
||||
Yes, Keg 👆
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#12
|
||||
|
||||
Different needles, different delivery, however not a whole lot of fuelling variance across the brands when it comes to the 72x72 300cc donks. Pretty much all running Vforce reeds coupled with a Keihin 36/38mm carb, and a free flowing exhaust. Ports for smooth power and excess squish/lowish comp.
Just a matter of finding a taper that provides the delivery style you like and then matching the clip position, pilot (and needle diameter; and/or slide number), and mains to suit particular engine and conditions. |
#13
|
|||
|
|||
You have to throw that garbage stock needle in the trash can. It is terrible. Goes from lean to rich and causes the bike to have weak bottom end and then explode into mid-range.
I like the NEDJ or N3CH needles Sent from my iPhone using Tapatalk |
#14
|
|||
|
|||
Got my needles in today. I have the NECJ needle, N3CH and N3CJ. What main and pilot have you tried in with the N3CH? I'm east coast, sea level to 1000ft.
__________________
2018 XC300 |
#15
|
|||
|
|||
Quote:
With the N3xx needles you will have to run a pretty fat main jet. I run N3CH 3rd clip, 180 main 42p A.S. 1.5 and jetting is spot on Sent from my iPhone using Tapatalk |
#16
|
|||
|
|||
Thanks for sharing. I have KEGS setting in there right now and will ride with it Friday and then try the N3XX combo after a few laps. Thanks!
__________________
2018 XC300 |
#17
|
|||
|
|||
NECJ was just too lean for my bike. Going to try the N3CH setup and also an NEDH for comparison.
__________________
2018 XC300 Last edited by thumperrider1; 04-09-2018 at 10:24 AM. |
#18
|
|||
|
|||
Quote:
NEDW #3 for the GP300 is pretty good too.
__________________
EC300 2019 (11 Gassers owned, many more to go) |
#19
|
|||
|
|||
Now my EC 300 2018 work perfect with NEDW at 3
MJ 172 PJ 42 AS 1 1/2 Alt sea level 5-15 degrees C. 95-98 octane gas but remove this damn cable choke, it is the cause of the majority of the problems |
#20
|
|||
|
|||
I was also told to ditch the choke. Plan to do that as well.
__________________
2018 XC300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Revised Jetting Specs NEDW | Jakobi | Enduro Intake/Carburetion - 2 stroke | 197 | 09-19-2014 08:17 AM |
'06 EC300 stock handlebar specs? | brider | Enduro Chassis & Body | 0 | 09-16-2013 03:08 PM |
What is the stock 200 needle and jetting specs | shaheeb | Enduro Intake/Carburetion - 2 stroke | 3 | 03-24-2012 10:56 PM |
2010 EC300 Factory Jetting Specs - WTF? | JP4 | Enduro Intake/Carburetion - 2 stroke | 197 | 07-04-2011 11:03 AM |