|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
09-17-2015, 02:24 AM
|
|||
|
|||
Big End Rebuild - crank seals
I am busy trying to arrange to do a big-end rebuild on my 2010 EC300.
the GG supplier near me has informed me that they have both crank bearings and the conrod, however the crank seals are not available and according to them are only available from GG. Anyone know if there is a cross-over seal from a different brand or if they are in fact available from a bearing shop?
__________________
2003 txt250 Pro 2013 Ossa 280i 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GG FSE 450 crank shaft and other parts [rebuild] | V1T0 | Enduro Engine 4 stroke (including EFI & Exhaust) | 8 | 10-27-2018 11:43 PM |
| 99 ec 200 crank rebuild | sweeper | Enduro Engine - 2 stroke | 5 | 03-09-2014 11:59 PM |
| 06 300 o-rings on crank? rebuild advice | hillbilly | Enduro Engine - 2 stroke | 1 | 03-19-2012 05:32 PM |
| Crank rebuild? | jayc | Enduro Engine - 2 stroke | 9 | 03-30-2011 02:36 PM |
| Crank seal gone on rebuild? | stay_upright | Enduro Engine - 2 stroke | 11 | 09-13-2009 03:49 AM |
Threaded Mode