|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1998 ec250 power valve tuning
Hi was wondering if it?s possible to change the rpm at which the power valve opens if so how and would a mechanical Luddite like myself be able to do it
|
#2
|
||||
|
||||
It can be adjusted.
You will need to pull the right side clutch cover off. There are some washers you can move around to adjust the preload on the power valve actuator. |
#3
|
|||
|
|||
Ok cool I?ve been told to put a lighter spring in as well how much of an adjustment is needed to get a reasonable amount of change my power band isn?t kicking in until I?m almost ready to change gear it?s daft want it at least half way if not sooner really
|
#4
|
||||
|
||||
First things first. Read the jetting threads. If it is still trying to clear out too rich a mixture, that is exactly how it will feel.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#5
|
|||
|
|||
on my 2006 I removed all of the pre load washers and ground the end of the springs down so there was minimal preload the shorter the spring the earlier it comes in some people have removed material from the OD of the spring and this makes the spring open quicker.
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
#6
|
||||
|
||||
Also pull the right side small PV cover off and verify the stud did not break off the PV actuator backing plate. That was a common failure for the early GG bikes.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1998 ec250 gasket kit? | vaughn | Enduro Engine - 2 stroke | 2 | 11-10-2018 07:26 PM |
1998 Ec250 Yokes | EC250 | Enduro Suspension | 11 | 10-24-2013 07:55 PM |
Loss of power - suspect power valve | Jonny Halls | Enduro Engine - 2 stroke | 4 | 01-22-2013 09:56 AM |
Checking for proper power valve operation 2003 EC250 | SideshowBob | Enduro Engine - 2 stroke | 4 | 04-08-2010 01:00 PM |
1998 Gas Gas ec250 | pferreira1970 | Enduro Electrical & Wiring | 0 | 10-19-2008 11:41 AM |