|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
99 EC250 CDI/Spark Diagnostics Help
Hello gassers, great site, great bikes...looking for some help to get my 1999 ec250 running from no spark condition. She's stranded out on the trail now so any help will be greatly appreciated and I will follow this thread to its completion.
Quick Recap: bike died during a mid rpm hill climb; absolutely no problems previously...fresh "300" rebuild, great runner... No spark at plug or wire, coil primary and secondary resistance good, stator resistances both good, not open to ground. CDI has around 100k Ohms from kill to ground but I don't know what else to check there. I'm looking for advice on how to rule out faulty CDI vs bad stator. Tried fresh plug/wires...disconnected kill at cdi...inspecetd all wiring, looks fine and this is the bare bones version...no lights/regulator, very simple wiring really. Cleaned connectors for insurance. How can I test stator output values? What should I get for voltage there? Any additional tests for CDI, or can I have it bench tested somewhere? Anyone have a compatible CDI to sell/loan; I'm in Colorado? Thanks in advance, eager to get her out of the woods. Cheers! |
#2
|
|||
|
|||
Might sound daft but have you continuity tests for a broke wire?
|
Tags |
cdi stator coil |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
99 no spark | c-152 | Enduro Electrical & Wiring | 10 | 06-30-2011 10:23 AM |
CDI? No spark | tommymoto | Enduro Electrical & Wiring | 4 | 02-28-2011 01:22 PM |
1997 EC250 Spark Arrestor Muffler | Dave Massingham | General Discussions & Announcements | 1 | 02-16-2011 09:13 AM |
No Spark.. (i think) | Todd5774 | Enduro Electrical & Wiring | 22 | 01-21-2011 09:43 AM |
Diagnostics Interface | iancp5 | Enduro Engine 4 stroke (including EFI & Exhaust) | 23 | 11-06-2009 04:25 AM |