|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Is my pipe bent
When I bought the bike the pipe look a bit bent at the first bend and I have though it never ran quite clean, but I don't have anything to compare it to.
I went to fit a bash guard the other night and could not get it on. It hits the pipe when swinging it up. I could probably get it on if I took the pipe of first but it would still very tight. Does this look bent? Pics not very good I am afraid. https://picasaweb.google.com/Jim.Clewitt/20130606 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bent foot peg pins | tnttimber | Enduro Chassis & Body | 3 | 11-03-2011 08:57 AM |
2011 six days pipe bent and dented | matt_tidball | Enduro Engine - 2 stroke | 3 | 08-24-2011 01:53 PM |
Radiator Bent | Niloz | Enduro Chassis & Body | 1 | 11-10-2008 01:18 PM |
bent pipe. | rupecopp | Enduro Engine - 2 stroke | 2 | 10-11-2008 11:14 PM |