|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
cracked case
My 03 300 had developed a ticking noise somewhere in the engine that I could hear at idle,turns out I found a small crack (about 1 inch) at the top of the reed housing.I wonder how this happened?I guess I can put some JB weld on it and call it good?Any other suggestions?Thanks.
|
#2
|
|||
|
|||
JB weld should do it. I used it on a clutch cover hole for years.
|
#3
|
|||
|
|||
Sounds like where the cases go together and the gasket is gone in that area. If so and if were mine I would replace the center case gasket.
|
#4
|
|||
|
|||
You are right,there is gasket material sticking out,there appears to be no seam there,I will look closer today and get a pic.Thanks.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tank cracked at mounting point | Bailey28 | Enduro Chassis & Body | 8 | 05-15-2013 01:47 AM |
Seat has cracked at the back - is this common? | stay_upright | Enduro Chassis & Body | 6 | 07-23-2012 06:53 PM |
LTR case saver | thespice | Enduro Engine - 2 stroke | 4 | 01-15-2011 08:51 PM |
Case hole? | Neil E. | Enduro Engine - 2 stroke | 4 | 11-29-2010 10:16 AM |
Messico Pipe cracked! | pbspecial | Enduro Engine - 2 stroke | 13 | 01-07-2009 09:28 AM |