|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Quote:
__________________
2004 Gas Gas Wild 300 ITP beads all around |
#12
|
||||
|
||||
Any Keihin agent should stock them. It's a standard Keihin needle. I believe Sudco are one of the main agents in the US?
|
#13
|
||||
|
||||
I would try a 40 pilot, needle clip in the #3 position based on you brief description of the midrange bog. With the larger load from the quad, I would keep going up on my main jet until the performance dropped off. You might be able to pull a up to a 175 at the higher elevations and it's important if you plan on spending alot of your time on the pipe/MJ.
Mike |
#14
|
||||
|
||||
Quote:
It had a #40 pilot and it was worse I think, Thats why I went with the #35 and went another half a turn out. I was going to up the main another size up and see..I also tried the needle in the middle and it had the hesitation so I went to the 2nd fron the top and it cleaned it up alot..
__________________
2004 Gas Gas Wild 300 ITP beads all around |
#15
|
||||
|
||||
The LTR powervalve cover helps with bottom end. We put one on a Wild HP 240 and it made a difference on the bottom end. I also have one on my EC200 and noticed a difference as soon as I put it on.
__________________
Todd A ------- 2003 EC/O 200 |
#16
|
||||
|
||||
Thanks Barkeater
__________________
2004 Gas Gas Wild 300 ITP beads all around |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Chain slider question. Please help | joey11 | Enduro Chassis & Body | 3 | 12-05-2008 06:43 AM |
chain slider / chain guide crossover? | bondo | General Discussions & Announcements | 1 | 09-01-2008 09:13 PM |