|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
18 EC300 Battery not charging FIXED
**Regulator/Rectifier is putting out DC voltage...rising & falling w/throttle
**Relay functioning correctly **Motor & starter running perfectly **Battery..new AntiGravity 8 cell small case..... runs down after each ride...I sometimes have to kick start. Last ride battery was at 8.6 volts at end of ride. Possible causes yet to be verified: #1 Diode at relay - Below is a quote from an old thread indicating it could be the diode attached to the relay. #2 Loose/faulty connection - I have traced most connections but could have missed something. Quote:
Thanks everyone!! Last edited by Tech; 09-08-2023 at 03:04 PM. Reason: solution to problem |
#2
|
||||
|
||||
Quote:
|
#3
|
|||
|
|||
Have not tested the diode. Not sure how to do this.
I have a Fluke 88V meter. Also, I am having trouble reading the wiring schematic. I do not understand how the Battery/Relay/Starter schematic interfaces with the rest of the wiring schematic. |
#4
|
|||
|
|||
Diode Test Video
Caution I saw this video on youtube about testing diodes but I don't know anything about this process, so be careful and use at your own risk.
https://www.youtube.com/watch?v=9LwDPHvzH90
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#5
|
|||
|
|||
PM Member Neil E
PM Member Neil E, he is the electrical guru on this board.
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
#6
|
|||
|
|||
More testing @ diode....view "J" on wiring schematic
**Varying DC voltage on Red wire while bike is running..14.3 max **Static DC voltage on Red/Yellow wire while bike is running & not running. Same voltage as + - on battery. **No readings on White/Black or Green/Yellow wires while bike is running or not running |
#7
|
|||
|
|||
Moto7man thanks for the compliment, but I'm not versed on the newer bikes. All I have is the '18 wiring diagram in the owner's manual. It is severely lacking in details. Does not show the stator. Does not show a diode module.
The only diodes I am aware of on the older bikes, are the ones in the voltage rectifier/regulator. The bikes have an AC powered CDI. I'm super busy right now with no time to investigate. I don't know where to get a proper wiring diagram. The red wire voltage at 14.3 sounds good.
__________________
2011 EC250E |
#8
|
||||
|
||||
Quote:
|
#9
|
|||
|
|||
Diagrams too large to download.
Rieju Linkhttps://static1.squarespace.com/static/5f7ca7769bb53012f2be84b3/t/5f7f666b728d3904359e4333/1602184895623/2021+Rieju+MR+Racing+Owners+Manual.pdf Pages 15, 16, 17 If that doesn't work try https://www.rieju-usa.com/downloads Thx for your help |
#10
|
|||
|
|||
2018 forward are all the same.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'18 EC300 (battery not charging) | TerraMoto | Enduro Electrical & Wiring | 12 | 07-17-2020 10:03 PM |
2018 EC300 Speedo Battery Code | malin | Enduro Electrical & Wiring | 1 | 07-31-2018 03:31 PM |
not charging battery | OLD.IT | Enduro Electrical & Wiring | 2 | 06-21-2015 03:01 AM |
Charging phone on 2011 EC300 | Quigs | Enduro Electrical & Wiring | 9 | 03-07-2015 12:55 AM |
Battery Not Charging | GLantern | Enduro Electrical & Wiring | 6 | 08-25-2013 03:45 PM |