TrailTech speedo -- brake caliper whole outside the arc

[AZRickD]

I finally got 'round to installing my Trail Tech Endurance with the cool home-fabricated mount above the tank bolt.

As I screwed the pick-up into the Nissin brake caliper unit, I couldn't help but notice that the pick-up hole would place the cable a good 1.25-inches outside the arc of the magna-bolt on the brake rotor.

Result, an otherwise functioning Trail Tech Endurance doesn't record speed.



Any quick fixes? The former owner said he fabbed a bracket. I gotta be missin' sumthin here.

[eff]

I screwed mine right in and it picks up the magnet just fine on my 2004 250. On mine this was the same location as the stock speedometer.

You can see it along with the magnet in this image: http://www.gasgasrider.org/gallery/d...0/100_1512.JPG

If you need to stick a magnet that came with the Trailtech to the rotor with some JB Weld.

[mike989]

[QUOTE=AZRickD

Any quick fixes? The former owner said he fabbed a bracket. I gotta be missin' sumthin here.[/QUOTE]

Maybe.
I installed one on my 04 GG300, and found the same problem. I used the stock pickup cable, and just snipped the wires on the stock cable up by the handle bars, I snipped the wires off the trail tech pickup sensor (6" down from the connector) and soldered(sp) it to the stock pickup cable. I used plenty of shrink tube for protection.
I did the same thing on my 04 GG quad.

[AZRickD]

Care to post pics (or e-mail them to me)?

I don't know where the stock pickup goes.

Thanks,

Rick

[eff]

See here

[eff]

Originally Posted by AZRickD

Care to post pics (or e-mail them to me)?

I don't know where the stock pickup goes.

Thanks,

Rick

Do you mean the cable? Yours is where the stock cable goes.

[AZRickD]

This is all very strange. The stock pickup goes in the li'l hole in the Nissin caliper, but that location places it nowhere close to where any magnet can be easily placed (say the famous KTM notch).

I could drill a 3/8" hole but that would give me not much room for error in that thin metal area.

[eff]

Look at this picture:
http://www.gasgasrider.org/forum/att...3&d=1198860123

You can clearly see how my stock magnet is mounted to the wheel hub (circled). If you don't have the stock magnet, then fabricate a small bracket and screw it into the existing hole in the hub. It takes a small allen cap screw, maybe 2mm. Attach your magnet to the bracket.