|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
06-23-2010, 08:06 AM
|
||||
|
||||
new clutch drive plates
ok i bought honda clutch drive plates, and now i need to put them in. im assuming they need to be soaked in oil correct? ive seen some that dont but i dont know the difference. how would you go about soaking them? old ice cream pail and some oil in the bottom?
__________________
03 ec250 hyde skidplate, cycra handguads, protaper contours "what? it seemed like a good idea at the time!" 
|
|
#2
06-23-2010, 09:09 AM
|
||||
|
||||
|
i have always heard that also.. and i usually put mine in a zip lock baggie with oil a day or so before install... don't know for sure, has never been a problem doing them that way...
__________________
broken down over 60 slow rider..
|
|
#3
06-23-2010, 09:33 AM
|
||||
|
||||
|
when you soak them don't soak them in a stack... you want oil all around them. i usually use a ziplock bag and move em around every 15 minutes or so, for an hour or 2. i dunno how long they really need to soak, but soaking them when they're not compressed in a clutch pack is the key. they need to swell a bit i would assume, or they'll just burn up when you slip them.. ice cream pail will work fine. just seperate the plates as best as you can.
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com 
|
|
#4
06-23-2010, 11:22 AM
|
||||
|
||||
|
thats what i always liked about the zip locks... you could move them around and make sure they all got oiled good with out getting it on your hands or anything else ending up in the oil....
__________________
broken down over 60 slow rider..
|
|
#5
06-23-2010, 12:15 PM
|
||||
|
||||
|
alright thanks guys. ive seen some that you dont need to soak, but i wasnt sure about the stock hondas.
__________________
03 ec250 hyde skidplate, cycra handguads, protaper contours "what? it seemed like a good idea at the time!"
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| broken clutch plates? | stainlesscycle | Enduro Engine - 2 stroke | 24 | 09-27-2011 05:39 AM |
| steel clutch plates | steve | Enduro Engine - 2 stroke | 3 | 03-15-2011 10:22 PM |
| clutch plates | mxdj2003 | Enduro Engine - 2 stroke | 4 | 11-02-2009 02:37 PM |
| Steel Drive Plates | nr1strange | Enduro Engine - 2 stroke | 1 | 08-11-2008 10:41 AM |
| New DP clutch plates won't fit - suggestions? | stay_upright | Enduro Engine - 2 stroke | 6 | 05-26-2008 10:59 AM |
Linear Mode
