|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power valve rotation
I'm doing some wrenching on the .05 EC250 to get her ready for this weekend's race. I took off the LTR PV cover on the left side to see how things were working.
I etched the end of the little rod inside the bearing (looks like a donut hole in a donut) and started up the bike. With the slightest of revs, the rod began to rotate counter clockwise. By the time I got to half throttle, the rod had rotated just beyond 90 degrees. Questions: is just over 90+ degrees the amount I should be looking for, and is this the rate of PV opening I should be expecting? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LTR Power valve cover | skid jackson | Enduro Product Reviews | 22 | 09-04-2017 02:42 PM |
Power Valve Removal | cdn280 | Enduro Engine - 2 stroke | 6 | 01-23-2010 05:34 PM |
Power valve malfunction | Warwick Simpson | Enduro Engine - 2 stroke | 2 | 08-27-2008 07:10 PM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |
Power Valve rebuild | Gas Stu | Enduro Engine - 2 stroke | 2 | 09-19-2007 12:38 AM |