|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
GasGas 300ec six dayz
Hello everyone. My name is Rob and I am the owner and developer for Synergy Seals. I am very excited to purchase this bike for many reasons primarily to ride second to develops. I look forward to discussing all about the GG.
Best regards Rob
__________________
www.synergyseals.com 209-938-9726 Being BOLD is BOLD! However, being confident is certain! Ride with confidence again! Made in the USA |
#2
|
|||
|
|||
Congrats on your new GasGas and welcome to the site. Look forward to seeing what you come up with for the GG's.
|
#3
|
||||
|
||||
I have run Rob's Synergy seals in my last two bikes, an 03 ktm 200 and an 06 250ec and I can attest, they do the job as advertised! Good Stuff!!!
Welcome, Rob and thanks for a great product!
__________________
Alan 14GasGas ec300r |
#4
|
|||
|
|||
The only seals I will run in my bikes now. Put them in my 97' Gasser w/WP forks. And I will put them in my new bike when I tear into the forks.
|
#5
|
||||
|
||||
Rob. Welcome to GasGasRider.org
Make me a seal for the top steering stem bearing, as there is nothing there from the factory. |
#6
|
|||
|
|||
Ditto. A seal for the stem would sell.
__________________
2018 XC300 |
#7
|
||||
|
||||
Come up with a fuel cap seal that works.
|
#8
|
||||
|
||||
The head seal should just be a matter of selecting the proper oring, just like the pre '10. The idea is to get a seal between the top edge of the neck and underside of the cup. I remove the powdercoat to do this. I see no reason way it can't work on the new frames as well.
|
#9
|
||||
|
||||
Glenn. That would work.
A seal that is made into the cup would be even better. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
04 gasgas 300ec | Moto-x | Enduro Chassis & Body | 0 | 03-27-2011 10:47 PM |
'02 300ec | Bultaco206 | General Discussions & Announcements | 2 | 01-23-2007 06:40 PM |